Brands
 
Shopping Cart
0 items
 

STRC Axial Wraith Alum. Suspension Links (STA80083/80083U/80083L)

STRC Axial Wraith Alum. Suspension Links (STA80083/80083U/80083L)

STRC Axial Wraith Alum. Suspension Links (STA80083).  You will use the same instruction below for STA80083U (Upper Link) and STA80083L (Lower Link)



Requires Axial AX80057 Rod Ends and AX80018 Rod End Links.  If you like, you can save the rod end links by cutting out the ones inside the plastic suspension links




Install the rod end links into the rod ends and thread in the included M3x16mm set screws about half way (8mm) into the rod ends.

Install the rod end assembly into the suspension links.  Be sure to use a small drop of blue loc-tite on the thread upon installation.



make sure that the shorter curved links goes with the bent upper link and the longer curved links goes with the straight lower links

remove the plastic suspension links from the skid plate using a 1.5mm hex wrench.  Install the aluminum links.  Note the orientation of the rod ends.



Next work on the axle side to install the suspension link.  It is easier to work one side at a time instead of removing the stock links completely.



Next remove the upper link from the axle mount.  Keep the hardware as you will be using them again.

Repeat the same steps above for the other end of the truck.




There are no products to list in this category.